Edge Drying

Wet edges on paper or board machines can be a headache. There can be different causes for the problem. There is usually a simple solution: adding electrical IR on the edges.


We have installed Edge Dryers on tissue machines, inside drying sections, after size press or on the reel. They all reach the same result: an overall increase in production capacity and full utilisation of available equipment. Our solutions can be adapted to your needs in terms of retraction, size and power control.


EdgeMaster™ in operation for Paper & Board


Contact us :



The simple solution for wet edges READ MORE >

Edge dryers to remove 5 % moisture

This installation is designed to remove up to 5 % moisture before the sizer as the pre-drying section has an important lack of drying on both edges.


The IR is normally used at 100 % and production capacity is immediately increased. The investment was paid back in less than 2 years.